Adjusting The Sound; Setting Bass And Treble; Setting The Equalizer; Sound Effect - Sonoro SO-310 Instrucciones De Manejo

3. Press the click wheel or the [OK] button on the
remote control to confirm the setting.
ð The display indicates [Light Low] (Fig. 21/B).
4. Adjust the brightness from 1–8 by rotating the
click wheel.
5. Press the click wheel or the [OK] button on the
remote control to confirm the setting.
i
The backlight is set automatically depending on
the ambient lighting.
8.6

Adjusting the sound

8.6.1 Setting bass and treble

When the device is switched on, the sound of the
audio playback can be adjusted via the bass and
treble controls.
Configuring settings via the remote control
Fig. 22: Adjusting the sound
1. Press the [Bass] or [Treble] button on the
remote control.
2. To adjust the bass, select [Bass] (Fig. 22/A) and
press the [VOL +] or [VOL ‐] button.
3. To adjust the treble, select [Treble] (Fig. 22/B)
and press the [VOL +] or [VOL ‐] button.
4. Press the [OK ] button or wait 10 seconds to
confirm the setting.
Configuring settings via the device
1. Press the [MENU] button in the front of the
device.
2. Turn the click wheel until [Bass] or [Treble] is
shown.
3. Press the click wheel to confirm your selection.
4. To configure the bass, select [Bass] and turn the
click wheel. To configure the treble, select
[Treble] and turn the click wheel.
5. Press the click wheel or wait 10 seconds to con-
firm the setting.
90

8.6.2 Setting the equalizer

Activating and setting the equalizer
Fig. 23: Setting the equalizer
1. Press the [MENU] button while the device is
switched on.
2. Turn the click wheel until [Equalizer Effect] is
shown (Fig. 23).
3. Press the click wheel to confirm your selection.
4. Turn the click wheel to select a default setting.
You can select one of the following default set-
tings:
n Maximum bass
n Maximum voice
n Maximum treble
5. Press the click wheel to confirm your selection.
ð The display shows the [EQ] symbol
(Fig. 23/1).
Deactivating the equalizer
7. Turn the click wheel in the [Equalizer Effect] sub-
menu until the display shows [Equalizer Off].
8. Press the click wheel to confirm your selection.
ð The [EQ] symbol no longer appears in the
display.
8.7

Sound effect

Switching the sound effect on
1. Press the [MENU] button while the device is
switched on.
2. Turn the click wheel until [Equalizer Effect] is
shown (Fig. 23).
3. Press the click wheel to confirm your selection.
4. Turn the click wheel until [Max. Stereo] is
shown.
5. Press the click wheel to confirm your selection.
6. Turn the click wheel until [Max. Stereo On] is
shown.
7. Press the click wheel to confirm your selection.
ð The sound effect is switched on.