Tabla de contenido
Avisos normativos
FCC Class B Digital Devices Regulatory Notice
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected
• Consult the dealer or an experienced radio or television technician for help
FCC Wireless Notice
This product emits radio frequency energy, but the radiated output power of this device is far below the
FCC radio frequency exposure limits. Nevertheless, the device should be used in such a manner that
the potential for human contact with the antenna during normal operation is minimized.
To meet the FCC's RF exposure rules and regulations:
• The system antenna used for this transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
• The system antenna used for this module must not exceed 4 dBi.
• Users and installers must be provided with antenna installation instructions and transmitter
operating conditions for satisfying RF exposure compliance
FCC Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received, including interference that may cause undesired
operation
ISED Statement
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire
de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement.
2
Manual del usuario de Thermo Scientific E1-ClipTip
Thermo Fisher Scientific
Tabla de contenido
