Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION
1.
Before assembling the solar water heater please ensure that all the components are presents. (see the appendix)
2.
Assemble stand according to assembly diagram.
3.
This system is only to be installed horizontally on the stand provided. It is not suitable for wall mounting.
4.
Take out vacuum tubes, place a black dust seal over the top of the tube. Lubricate the top of the tube with soapy
water for ease of insertion into the tank.
5.
Place 2-3 anodes in the tube closest to the hot water outlet.
6.
Insert the tube into the aperture provided n the tank.
7.
Carefully push the tube past the silicone seal in the tank by turning it continuously until the bottom of the tube has
cleared the tube holder. Then slowly lower then tube into then cradle provided in the tube holder. Take care not to
dislodge the seal when inserting tube .
8.
Connect the pipes and fitting according to the connection diagram.
9.
Insulate all pipes and fitting from the tank to ensure heat is not lost.
10. Install a TP valve on the hot water outlet as a safety precaution.
11. When finish installation, fill water into the tank, check whether there are no leaks in the system, connect of tubes
and manifold, the main pipes of the inlet and outlet£ªcheck whether the vent-pipe can exhaust well£ªcheck whether
the manifold and stand are fixed well and the whole system is steady enough on the roof.
ATTENTION ON INSTALLTION
•
The installing person works on the roof, please do the safety precautions!
•
Check building roof bearing capacity to find best position for carrying the system weight. The installation should
not break the building structures and avoid the light pollution to neighboring buildings caused by the solar collector
reflection.
•
The solar water heater should face sun. Guarantee the max area of collectors face the sunlight all day.
INSTALLATION MANUAL
5
Tabla de contenido
