Fitting The Toe Boards - TELETOWER TTA02 Manual De Instrucciones

English
3. FITTING THE TOE BOARD
The Toe board is supplied as six sections in a canvas carry bag with Toe board fixing
brackets (x8) and cross-head screws (x32). Screw the brackets into the tapped holes
along the side of the platform as shown in Figure 3.1. The Toe boards are supplied
ready to use. Figure 3.1 shows the front Toe boards being fitted.
The front and rear boards have locating pins fitted which engage with the Toe board
brackets on the edge of the platform. Note that the rails use different spacing between
the locating pins. The side toe boards do not have pins but each have four hooked -
shaped lugs that engage with slots in the edges of the front and rear toe boards.
TOE BOARD
FIXING BRACKET
Take a section fitted with pins and
1.
align the pins with the receptacles
(from above) and lower it into place,
Figure 3.1.
Repeat for the other three sections
2.
with pins.
Take a side Toe board and align the
3.
lugs with the slots in the front/rear
toe boards, see Figure 3.2.
Lift the front and then the rear Toe
4.
boards a little (1). Guide the lugs
into the slots (2). Lower the front and
rear toe boards (3) to lock together.
The side toe board cannot now be
removed without lifting the front and
rear toe boards.
Repeat for the other side toe board
5.
to complete.
14
PLATFORM
FRONT OR REAR
TOE BOARD
TOE BOARD
FIXING BRACKET
TOE BOARD
FITTED
CLOSE UP OF
TOE BOARD
BRACKET
REAR
3.2
TOE BOARD
SIDE
TOE BOARD
2
SLOPING
SURFACE
(TOP)
FRONT
TOE BOARD
1 3
3.1
LOCAT
PINS