Idiomas disponibles
Idiomas disponibles
GB
RX-MULTI 300 A 868 MHz
Manuale Istruzioni
1. RX-Multi drawing
2. Brand selector
With 8 bits dip witches, the user can make different combinations for different remote brands. The brands selection is
shown below in table 1.
3. Learn Button and LED
In RX-MULTI receiver, there are 2 independent channels. Each channel has independent learn button SI, S2 and Ll,
L2 corresponding led.
4. Power Input Selector
The RX-MULTI can work at input AC/DC 12V~30V. However, it's better to change the jumper according to the power
input. If the input is over 24V, shorten pin 2&3; shorten 1&2 if input is under 24V.
5. Exchangeable Memory Card
The memory card can be removed from board to inserí in a different receiver.
6. How to entry remote and Erase all remote Entry one button or remote:
1. First, select the correct brand for remote that will be entry (by dip switch).
2. Press the learn button, LED turns on. Press the button on the remote, the LED S1/S2
flashes 4 times, this remote button entry into the RX-MULTI successfully.
3. Repeat step 2 for another button.
4. Both channels work the same.
7. Faac remote controls rolling code series SLH
Only Master remote controls can be memorized, to check if the remote control is Master keep any key pressed, the
LED must flash briefly and then turn on steadily.
Store a Faac series SLH remote control:
put the Dip-Switches as indicated (pos. 4 for 433 Mhz, pos. 20 for 868 Mhz); set the remote control by pressing but-
tons 1 and 2 together and releasing as soon as the LED starts to flash; press on the receiver the key of the desired
channel (S1 or S2), the relative LED turns on; press the key to be memorized on the Faac remote control, the led
on the receiver stops, press the key to be memorized on the Faac remote control again, the receiver LED flashes to
indicate that it has been memorized. The operation must be performed quickly to prevent the receiver from leaving
the learning phase. Remember that each remote control must be memorized in this way, the copy procedure between
Master remote controls is not enabled on compatible receivers.
8. Erase all data in memory card:
Pressing and holding either learn button, the LED starts flashing. Keep pressing this button until the LED turns off. All
data in the memory card will be erased permanently.
Notice: Be carefully at erasing all data in the memory card. The data will be erased permanently and cannot be reco-
vered.
WARNING!
It is important to follow the manual for your safety.. Multiservizi accepts no responsibility for incorrect use of
the product that causes damage to property and / or people.
DANGER
Make sure the device is not live before doing any work.
THE INFORMATION IN THIS INSTALLATION MANUAL ARE SUBJECT TO CHANGE WITHOUT NOTICE.
Distributed by MULTISERVIZI - VIA TRENTO, 100 - CAPRIANO DEL COLLE (BS) ITALY - 030 974 54 00 - [email protected]
