GE PP989 Manual Del Propietario E Instrucciones De Instalación página 24

A TTAChING A BloWeR
14
TRANsITIoN DuCT
Use a blower transition duct for all downward
duct installations to connect to 6" round standard
ductwork . This 3 ⁄ " x 10" rectangle to 6≤ round
1
4
transition duct is available at your local building
supply store .
Screws
Remove the cardboard packing in the blower outlet .
Install the transition duct to the blower outlet . Secure
all joints with duct tape to assure an airtight seal .
CoNNeCTING The DuCTWoRk
15
Connect the ductwork prepared in Steps 5 and 6 to
the blower transition duct .
BloWeR eleCTRICAl
16
CoNNeCTIoNs
• Loosen the two screws and remove and discard
the sheet metal strap covering the 5-pin connector
on the cooktop bottom . Save the screws for
reinstallation later .
Installation Instructions
INsTAllING The CookToP
Screw
(on other
side)
Remove screws
and discard
strap
24
B loWeR eleCTRICAl
16
CoNNeCTIoNs (cont.)
• Connect the 5-pin plug on the blower assembly to
the matching 5-pin receptacle on the bottom of the
wire enclosure .
Fold all wires into the electrical enclosure . Secure the
enclosure with the screws removed earlier, making
sure that no wires are trapped
•
5-pin
connectors
.
5-pin
connectors
Electrical
enclosure
Flexible
conduit