Perel LEDA7001NW-BM Manual Del Usuario página 5

LEDA7001NW-BM/LEDA7002NW-BM/LEDA7003NW-BM/LEDA7005NW-BM
Mounting
1. This luminaire does not have a built-in device to disconnect it from the electric
mains. Make sure to electrically isolate the luminaire before installation or
maintenance activities are performed.
Use the mounting bracket to determine the location of the mounting holes.
2. Drill the holes and secure the bracket using screws and wall plugs.
3. Connect the power cable to the screw terminal. Make sure there is no strain on the
cable; leave sufficient slack.
If the power cable is damaged, it must be replaced by the manufacturer, his service
agent, or a similar qualified person in order to avoid any hazard.
4. To point the lamp in the desired direction: loosen the hinges using a screwdriver.
5. Tilt the lamp in the desired angle and tighten the hinges.
V. 02 – 01/04/2019
N = neutral, blue
E = earth, yellow/green
L = line, brown
5 ©Velleman nv