Safety Instructions; User Manual - Toolland AC06 Manual Del Usuario

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its
lifecycle could harm the environment. Do not dispose of the unit (or batteries) as unsorted
municipal waste; it should be taken to a specialized company for recycling. This device should
be returned to your distributor or to a local recycling service. Respect the local environmental
rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Toolland! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer.
2.

Safety Instructions


Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.

Make sure that the available voltage does not exceed the voltage stated in the specifications of this
manual.

Do not crimp the power cord or leads and protect them against damage. Have an authorised dealer
replace it if necessary.

Do not use the device when damage to housing or cables is noticed. Do not attempt to service the
device yourself but contact an authorised dealer.

Note that damage caused by user modifications to the device is not covered by the warranty.
V. 04 – 11/01/2018

USER MANUAL

This device can be used by children aged from 8 years and above, and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or
instruction concerning the use of the device in a safe way and understand
the hazards involved. Children shall not play with the device. Cleaning and
user maintenance shall not be made by children without supervision.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid hazard.
The battery terminal not connected to the chassis has to be connected first.
The other connection is to be made to the chassis, remote from the battery
and fuel line. The battery charger is then to be connected to the mains
supply.
After charging, disconnect the battery charger from the mains supply. Then
remove the chassis connection and then the battery connection.
Be very careful: touching live wires can cause life-threatening
electroshocks.
Do not touch the device during operation as the housing heats up.
Keep this device away from rain, moisture, splashing and dripping liquids.
Never put objects filled with liquid on top of the device.
Disconnect mains power when device not in use. Handle the power cord by
the plug only.
Always wear safety goggles when handling batteries.
AC06
3 ©Velleman nv