Cleaning And Maintenance - HQ-Power PROMIX50N Manual Del Usuario

4. Overview
Refer to the illustrations on page 2 of this manual.
1. MIC PAN: Select the MIC L/MIC R to the master output left or right mix.
2. MICRO: Adjust the overall level of the MIC channel.
3. TALKOVER: Press to lower the overall level of all the connected sources by 12 dB except the MIC
channel. This allows you to talk over the music.
4. SLIDE CHANNEL A: Slide to control the input level of channel A.
5. PHONE 1/LINE 1: Switch to select the phone or line level for channel A.
6. SLIDE CHANNEL B: Slide to control the input level of channel B.
7. PHONE 1/LINE 2: Switch to select the phone or line level for channel A.
8. SLIDE CHANNEL CD: Slide to control the input level of channel C.
9. STEREO/MONO: Allows you to select the stereo or mono output mode.
10. CROSSFADER: Fader to mix the A and B sources.
11. MASTER OUTPUT LEVEL: Adjust the overall level.
12. HEADPHONE JACK: Input jack for your headphones.
13. DISPLAY: Indicates the left and right levels of the master output.
14. ON-OFF SWITCH
5. Connection

Always make sure to switch off all devices before connection.

Do not use excessive long cables (> 15 m).

Be sure to insert plugs and jacks tightly. Loose connection can cause
hum and noise that could damage your speakers.

Use appropriate quality shielded audio cables throughout your system.

Take care to connect only one cable at a time.
6. Operation

Always make all audio connections prior to switching on the mixer.
Switch off the mixer prior to disconnect all audio connections.

Always use the included power adapter or an exact equivalent.

Always switch amplifiers on last and off first. Set master faders or
volume controls on minimum and the amplifier gain/input controls
down. Wait before turning up the volume to prevent transients, which
may cause severe speaker damage.

Use restraint when operating controls. Try to move them slowly. Rapid
adjustments could damage speakers to amplifier clipping.

Avoid amplifier clipping at all costs. Clipping is when the power
amplifier is distorting and working beyond its limits, and occurs when
the red LEDs start flashing. Amplifier distortion is the major cause of
speaker failure.
7.

Cleaning and Maintenance

Never use spray cleaners on the slide controls. Residues cause excessive dirt build-up and this will void
your warranty. In normal use, slide controls can last for many years. Consult a professional technician if
they malfunction.
V. 01 – 16/05/2017
PROMIX50N
WARNING
WARNING
4 ©Velleman nv