Brother 885-X06 Manual De Instrucciones página 46

Ocultar thumbs Ver también para 885-X06:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

USING ATTACHMENTS AND APPLICATIONS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Position the fabric (wrong side facing up)
4
under the presser foot. Lower the needle
3 mm (1/8 inch) from the edges of the
fabric, lower the presser foot, and then
sew 2 or 3 stitches.
1
1 Needle
2 3 mm (1/8 inch)
Raise the needle and the presser foot, then
5
hold the ends of the upper and lower
thread to prevent them from being pulled
out of the fabric and pull the fabric out
from the front of the presser foot.
Holding both threads, pass them through
6
the curled part of the presser foot and pull
them toward the back of the presser foot.
Wrap the fabric around the curled part of
the presser foot in the same way. Position
the edge of the fabric just behind the
needle and lower the presser foot.
Without allowing the fabric to stick out
7
from the right side of the presser foot,
lightly pull on the thread while slowly
sewing.
45
2
2
After sewing 2 (3/4 inch) to 3 cm (1 1/8
8
inches) of the fabric, release the thread
and guide the fabric from the front of the
presser foot with your both hands. Keep a
uniform amount of fabric wrapped around
the presser foot curl until the seam is
completed.
■ If too little fabric is wrapped around the
curl, then a threefold seam is not being sewn
Pull the fabric held in your right hand to the left in order
to increase the amount of fabric wrapped in the presser
foot curl. At the same time, carefully guide the fabric to
the right with your left hand.
■ If too much fabric is wrapped around the
curl, then a wide threefold seam is being
sewn
Pull the fabric held in your right hand to the right in
order to decrease the amount of fabric wrapped in the
presser foot curl. At the same time, carefully guide the
extra fabric to the left with your left hand.

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido