Dmx Mode; Installing The Battery - HQ-Power HQLE10036 Manual Del Usuario

6.5

DMX Mode

The DMX mode allows you to control the device with any universal DMX controller.
All DMX-controlled devices need a digital start address so that the correct device
responds to the signals. This digital start address is the channel number from which the
device starts to "listen" to the DMX controller. The same starting address can be used
for a whole group of devices or an individual address can be set for every device.
When all devices have the same address, all the units will "listen" to the control signal
on one particular channel. In other words, changing the settings of one channel will
affect all devices simultaneously. If you set individual addresses, each device will
"listen" to a separate channel number. Changing the settings of one channel will only
affect the device in question.
To set the device to work with a DMX controller:
1. Press MENU and select the DMX mode.
2. Select the DMX start address and confirm.
Start Addresses
Use the table below to define the correct address. The table shows the settings for units
1 to 3. Apply the same principle for the other units. Example:
channel mode
13 start address
channel
DMX Channel Values
Refer to the illustrations on page 3 of this manual.
7. IR Remote Controller
7.1

Installing the Battery

Do not puncture batteries or throw them in fire as they may explode. Do not attempt to
recharge non-rechargeable batteries (alkaline). Dispose of batteries in accordance with
local regulations. Keep batteries away from children.
Remove the battery from the remote control if it will be stored for a long period.
1. Open the battery compartment and install the battery according to the correct
polarity.
2. Close the battery compartment.
V. 03 – 18/07/2018
HQLE10036
1 st unit 2 nd unit
1 14 (1 + 13)
1 - 13 14 - 26
3 rd unit
27 (14 + 13)
27 - 39
11
highest start address
500
©Velleman nv