Tabla de contenido
LOCATION OF CONTROLS
16) DUST COVER
17) LEFT SPEAKER
18) VOLUME KNOB
19) POWER ON/OFF BUTTON
20) POWER LED INDICTOR
21) RIGHT SPEAKER
22) HI LOW TONE CONTROL
23) AUTO STOP LED INDICATOR
24) SPINDLE ADAPTOR
25) 33/45 RPM SPEED SELECTOR
26) PICK-UP HOLDER
27) LINE OUT SOCKET
28) FM ANTENNA
29) AUTO STOP SWITCH
30) AC CORD
CAUTION:
USAGE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE
SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
THIS UNIT SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT QUALIFIED SERVICE
PERSONNEL.
PRECAUTIONS FOR USE
INSTALLATION
•
UNPACK ALL PARTS AND REMOVE PROTECTIVE MATERIAL.
•
DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE MAINS VOLTAGE AND BEFORE
ALL OTHER CONNECTIONS HAVE BEEN MADE.
•
DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF SEVERAL CENTIMETERS
AROUND THE UNIT FOR VENTILATION.
CONNECTION
3.
CONNECT THE POWER CORD TO AC OUTLET
4.
SWITCH THE SYSTME TO " POWER ON " POSITION. IF THE POWER LED INDICATOR IS ON WITH RED
LIGHT, IT'S MEAN THE POWER SUPPLY IS NORMAL. NOW YOUR SYSTEM IS READY TO PLAY THE
MUSIC.
PHONO
NOTED:
REMOVE THE STYLUS PROTECTOR.
-
-
BE SURE THAT THE TONE ARM IS BEING DETACHED FROM THE TONE ARM
REST BEFORE OPERATING AND RE-SECURED AGAIN AFTERWARDS.
8.
SET THE SPEED SELECTOR TO THE PROPER POSITION DEPENDING ON
THE RECORD TO BE PLAYED.
9.
PLACE THE RECORD ON THE PLATTER (USE THE SPINDLE ADAPTOR IF REQUIRED).
10. LIFT THE TONE ARM FROM THE REST AND SLOWLY MOVE IT TO THE RECORD SIDE.
THE PLATTER WILL START TO ROTATE.
11. PLACE THE TONE ARM TO THE DESIRED POSITION OF THE RECORD.
12. ADJUST THE VOLUME TO THE DESIRED LEVEL.
13. AT THE END OF RECORD, THE PLATTER WILL AUTOMATICALLY STOP ROTATING. LIFT THE TONE ARM
FROM THE RECORD AND RETURN IT TO THE REST.
14. TO STOP MANUALLY, LIFT THE TONE ARM FROM THE RECORD AND RETURN IT TO THE REST.
REMARK: AS SOME KIND OF RECORD THE AUTO-STOP AREA WAS OUT OF THE UNIT SETTING, SO IT WILL
STOP BEFORE THE LAST RACK FINISH. IN THIS CASE, SELECT THE AUTO-STOP SWITCH TO " OFF
" POSITION AND THE AUTO-STOP LED INDICATOR (8) WILL TURN ON, THEN IT WILL RUN TO THE END OF
THE RECORD BUT WILL NOT STOP AUTOMATICALLY (TURN OFF THE UNIT BY POWER BUTTON OR SWITCH
BACK THE AUTO-STOP SWITCH TO " ON " POSITION TO STOP THE PLATTER ROTATE). THEN PUT BACK THE
TONE ARM TO THE REST POSITION.
E-1
Tabla de contenido
