Velleman VMM502 Manual Del Usuario página 18

Let's get started!
Step 1
 Insert the micro:bit into the BoB and plug in the micro-USB cable. Then, plug in the OLED as shown.
You should be able to plug it into any of the three rows.
 Plug the buzzer into pin 0 (P0).
 Plug in the moisture sensor to P1. Make sure the colour of the wire follows the coloured pins on the
break out board.
Step 2 – Pre-Coding
Refer to Project 1, Step 3 – Pre-Coding.
 Click on Tinkercademy
components in your kit.
V. 01 – 17/01/2019
VMM502
or OLED inside the Code Drawer to find our custom blocks for the various
18 ©Velleman nv