Operation Instructions; Gas And Oil Fill-Up; Blade Control - Urrea PP921A Manual De Usuario

3. Then remove the dipstick and check the oil
Level . The oil level must be between the Min
and Max marks on the dipstick. If near the lower
level ,fill to upper lever with the recommended
oil((SAE30 or equivalent). Do not overfill. Wipe
away any spilt oil.)
4. Align the ribs of the cap with the groove of
the filler neck. Then rotate 1/4 turn to secure it.
FILLING WITH ENGINE FUEL
DANGER: Always use clean, fresh unleaded
petrol. Purchase fuel in quantities that can be
used within 30 days. Never mix oil with petrol.
DANGER: Do not fill into the base of neck
to allow for fuel expansion. Do not overfill the
fuel tank.
DANGER! WARNING!: Petrol is highly flam-
mable and extreme precaution must be taken
when handling or working with it. Keep out of
reach of children.
DANGER: To prevent engine damage the en-
gine is shipped without oil or petrol. The engine
must be filled with the correct grade of oil and
petrol before starting the engine.
WARNING!: Refuel in a well-ventilated area
with the engine stopped. Do not smoke or allow
flame or sparks in the area where the engine is
refueled or where petrol is stored. Avoid repeat-
ed or prolonged contact with skin or inhalation
of vapour.
1. Clean the area around the petrol filler cap
before removing the cap. Remove the warning
tag,check the fuel level.
2. Refill the tank if the fuel level is low.
3. Refuel carefully to avoid overfilling or
spilling fuel. There should be no fuel in the filler
neck.
4. Clean up any overflow or splashes of petrol
before starting the engine.
5. Tighten the filler cap after filling, finger
tight on.
ADJUSTMENT
SETTING THE CUTTING HEIGHT
WARNING!:
Adjust the cutting height only
When the engine is switch off the spark plug
Boot has been pulled.
The cutting height is centrally adjusted with
Cutting height adjusting handle. Different
cutting Heights can be selected.
16
Pull the adjusting handle out and select the
Desired cutting height. The handle snaps
Into the desired position.
From position 1 to position 7 . The cutting
height Range from 25mm to 75 mm

OPERATION INSTRUCTIONS

GAS AND OIL FILL-UP

Refer to the separate engine owner's manual
for additional engine information.
1. Add oil provided before starting unit for the
first time out of the box.
2. Service the engine with gasoline as instructed
in the separate engine owner's manual.
WARNING: Use extreme care when handling
gasoline. Gasoline is extremely flammable and
the vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and other
sources of ignition.

BLADE CONTROL

The blade control is attached to the upper han-
dle of the mower.
Depress and squeeze it against the upper han-
dle to operate the unit. Release it to stop engine
and blade.
WARNING: This blade control is a safety de-