Genius Audio GLT-85.4D Manual Del Usuario página 17

AMPLIFIER GLOSSARY TECHNICAL AND FUNCTIONS
1. "Front" RCA Input
Use high quality stereo RCA Genius cables, connect the
signal from the audio player to the RCA inputs of the
amplifier.
2. "Front" / "Rear" Sens Level
Adjust the sensitivity level "preamplifier" amplifiers. The
minimum sensitivity level is 200mV, while the highest level
is 6V.
3. "Front" High Pass Crossover
Adjust settings of the frequency of High Pass Crossover. The
adjustable frequency range is 40Hz-400Hz. The lower the
setting, filtered frequencies in the audio signal. (All frequen-
cy which lies below the adjustment will be filtered). All audio
signals that are above the set level pass to 20kHz.
4. Input Selection Switch
If you choose the 3CH (3 Channels) this option allows front
and rear channels receive the signal from the front RCA
inputs. If you choose the 5CH (5 channels) input option. This
allows inputs RCA front, rear have their separate entrances
and the output of the subwoofer is linked to the input REAR
(Rear) Amplifier.
5. "Rear" RCA Input
Use high quality stereo RCA Genius cables, connect the
signal from the audio player to the RCA inputs of the
amplifier.
6. "Rear" Sens Level
Adjust the sensitivity level "preamplifier" amplifiers. The
1 7
10 2 4
GL TECHNOLOGY
GLT-85.5D
9 8 5
GLT-85.5D
3 3 6
www.geniuscaraudio.com
minimum sensitivity level is 200mV, while the highest
level is 6V.
7. Sens Level "Subwoofer"
Amplifiers adjust the level of "preamplifier" sensitivity.
The minimum sensitivity level is 0.25V, while the
highest level is 6V.
8. BASS BOOST
Boost control low frequency adjustable from 0 db to 18
db
9. Low Pass Crossover "Subwoofer"
Adjust the frequency setting Low Pass Crossover. The
adjustable frequency range is 50Hz-250Hz. The higher
the setting, filtered frequencies in the audio signal. (All
frequency that are above adjustment will be filtered).
All audio signals which lies below the level set to 10 Hz
pass.
10. Power LED
When the amplifier is switched on and in operating
condition, this LED will light blue.
11. Power INPUT
Input B (+) and the pole to ground (GND) use 4 AWG
while the remote uses an entry-gauge 12 AWG (REM
terminal is used to turn on and off remotely the
amplifier when applied to + 12V )
12. Terminales de Altavoz
The speaker terminals are nickel plated allowing
connection cables maximum size 10 AWG feeding the
horn. NOTE: The configuration of each channel
must be verified by qualified personnel.
11
5 Channel "CLASS D" • 2 ohm Stable Stereo • Bridgeable MOSFET
GLT-85.5D
12
- 17 -