Desa 28BN Manual Del Propietário página 5

ASSEMBLY
Continued
6. Place lower mast inside base assembly (see Figure 6). Bottom of
lower mast has cut out section that slips into base assembly. Us-
ing 10 screws provided, attach to base assembly and back plate.
7. Remove 4 screws from control cover on back of upper mast
assembly (see Figure 7). Carefully pull control cover from as-
sembly and unplug electrode wire from piezo ignitor. The ig-
nitor will stay assembled to the control cover.
8. Slide upper mast assembly over lower mast and install using
4 screws provided (see Figure 8).
Lower Mast
Bottom of
Lower Mast
Center
Wrapper
Figure 6 - Attaching Lower Mast
Control Cover
Upper Mast
Assembly
Electrode
Wire
Piezo Ignitor
Figure 7 - Removing
Control Cover
For more information, visit www.desatech.com
For more information, visit www.desatech.com
107396-01F
Screw
Back
Plate
Base Assembly
Upper Mast
Screw
Assembly
Screw
Lower
Mast
Figure 8 - Attaching Upper
Mast Assembly
9. Using hose and regulator assembly provided, route hose up through
mast from inside base assembly. Screw hose fitting onto inlet of
valve and tighten with 9/16" open end wrench (see Figure 9).
10. Using only a 20 lb. propane/LP cylinder, not included (see
safety information for proper cylinder selection), connect the
hose/regulator assembly to the cylinder (see Figure 10). When
connecting regulator assembly to cylinder valve, hand tighten
nut clockwise to a positive stop. DO NOT use a wrench to
tighten. Use of a wrench may damage quick closing coupling
nuts and result in a hazardous condition.
Figure 9 - Installing Hose and Regulator Assembly
Hose/Regulator
Assembly
Figure 10 - Connecting Hose/Regulator Assembly to Propane/LP
Cylinder
ASSEMBLY
5 5
Gas Valve Inlet
Gas Hose/
Regulator
Assembly
Base
20 lb. Propane/LP
Cylinder