Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Operating Instructions
5.7 Overview of parameters
Menu item
Description
Hysteresis function:
SP1 / SP2
Switching point (switching device 1 / 2)
Window function:
FH1 / FH2
Window High (switching output 1 / 2)
Hysteresis function, reset switching
RP1 / RP2
point, switching output (1, possibly 2)
Window function: Window Low switching
FL1 / FL2
output (1, possibly 2)
EF
Extended programming functions
Resetting of the set parameters back to
RES
the factory settings
Switching delay time which must not
DS1 / DS2
be interrupted until an electrical signal
switch takes place (SP1, possibly SP2)
Reset switching delay time which must
not be interrupted until an electrical
DR1 / DR2
signal switch takes place (RP1, possibly
RP2)
Switching function (switching output
OU1 / OU2
1 / 2)
OU3
Output signal switchover
POL1 / POL2 Switching logic (switching output 1 / 2)
Measuring range scaling/Turn down
ALOW
(analog value, start value)
Measuring range scaling/Turn down
AHGH
(analog value, end value)
8024946 | SICK AG
Subject to change without notice
5. COMMISSIONING, OPERATION
Parameter
0.25 ... 100% of the measuring range
0.25 ... 100% of the measuring range
0 ... (switching point – 0.25% of the
measuring range)
0 ... (Window High – 0.25% of the measuring
range)
Yes / No
0.00 ... 65.00 s
0.00 ... 65.00 s
HNO = Hysteresis function, normally open
HNC = Hysteresis function, normally closed
FNO = Window function, normally open
FNC = Window function, normally closed
I = 4 ... 20 mA
U = DC 0 ... 10 V
PNP, NPN
Corresponding analog output
Corresponding analog output
O P E R A T I N G I N S T R U C T I O N S P B S p l u s
PBS plus
Factory setting
Nominal pressure
Nominal pressure
Nominal pressure – 10%
Nominal pressure – 10%
0.00 s
0.00 s
HNO
I
PNP
Measuring range
beginning
Measuring range end
4 7
Tabla de contenido
