Remote Control; Important - ayerbe 587300 Manual De Instrucciones

4. Place the power head back on the container, aligning the top section with the latches, and snap into
place. (fig. 4)
OPERATING INSTRUCTIONS: DRY VACUUMING
6. Insert the locking end of the hose into the vacuum port on the power head and lock in place. Push the
required attachment onto the free end of the hose or extension. (fig. 5)
7. Plug in the power cord into the outlet and hang the vacuum onto the rack or use off the rack . (fig. 6)
8. Turn the motor on by flipping the switch to the 'I' ON position. (fig. 7) For remote control use, set the
power switch to remote control position "
button on the remote control handle for at least one second. (fig. 8&9)
9. Once you have completed vacuuming, flip the switch to the 'O' OFF position or press the 'O' OFF
button on the remote control at least one second.
O = OFF
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.
LIQUID VACUUM OPERATION
LIQUID VACUUMING
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED
'SAFETY INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS WITH FLAMMABLE
GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS
INCLUDE BUT ARE NOT LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE
PAINTS, GASOLINE, ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE
NOT LIMITED TO; COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK OF
HEALTH HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
WARNING:
DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC

IMPORTANT!

When vacuuming large quantities of liquids, we recommend that you remove the
vacuum from the mounting rack and put it on the floor. The vacuum can be heavy when full of liquids
and may be difficult to remove from the rack.
1. Verify that the power cord is disconnected from the outlet. Verify that the container is clean and free
of dust and dirt. (fig. 1)
2. Remove cartridge filter, then carefully install the foam sleeve filter over the filter cage and place the
power head back on the container. (fig. 2) See filter installing instructions on page 26.
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.
OPERATING INSTRUCTIONS – WET VACUUMING
3. Fit the desired nozzle to the vacuum hose. (fig. 3)
4. Verify that the switch is in the 'O' OFF position before plugging the power cord into the outlet. (fig. 4)
5. For large amounts of liquid vacuuming, it is recommended to place the vacuum on the floor. Turn the
motor on by flipping the switch on the power head to the 'I' ON position or flip the switch to the
Remote Control Position and use the 'I' ON button on the remote control. (fig. 5 & 6)
CAUTION:
DO NOT GET THE REMOTE CONTROL WET – This will void its warranty.
I = ON
" and turn the vacuum on by pressing the 'I' ON

= Remote Control

23