Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3.
Place spray gun on hook attached to accessory tray on
right side of unit (Figure 15).
4.
Hang high pressure hose on hook attached to
accessory tray on left side of unit as shown on page 5.
How to Use Spray Tips
The quick–connect on the nozzle extension allows you to
switch between four different spray tips.The spray tips vary
the spray pattern as shown (Figure 16).
CAUTION
A pressure washer produces a high pressure spray
which increases risk of injury and damage to unit.
• NEVER exchange spray tips without locking the safety latch
on the trigger.
Follow these instructions to change spray tips:
1.
Engage trigger lock on spray gun.
2.
Pull back collar on quick–connect and pull current
spray tip off. Store spray tips in holder provided on the
nozzle extension.
3.
Select desired spray tip:
•
For gentle rinse, select white 40° spray tip.
•
To scour surface, select yellow 15° or red 0° spray
tip.
•
To apply chemical, select black spray tip.
Figure 16 — Spray Tip Spray Patterns
Low Pressure
High Pressure
15° Yellow
40° White
3000 PSI Pressure Washer
Black
Use to apply
chemical
0° Red
4.
Pull back on collar, insert new spray tip and release collar.
Tug on spray tip to make sure it is securely in place.
5.
For most effective cleaning, keep spray tip from 8 to
24 inches away from cleaning surface. If you get spray
tip too close, you may damage cleaning surface.
6.
DO NOT get closer than 6 inches when cleaning tires.
Cleaning and Applying Chemical
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
CAUTION
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
To apply detergent follow these steps:
1.
Review spray tip use.
2.
Prepare detergent solution as required by manufacturer.
3.
Hang detergent solution on "J" hook attached to
accessory tray, as shown in Figure 17.
Figure 17 — Insert Filter into Container
3.
Place small filter end of detergent siphoning tube into
detergent container.
CAUTION
Keep the chemical injection tube from coming in contact
with the hot muffler.
• When inserting filter into a detergent solution bottle, route
tube to keep it from inadvertently contacting hot muffler.
4.
Make sure black spray tip is installed.
NOTE: Detergent cannot be applied with the high
pressure spray tips (White,Yellow, or Red).
5.
Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray
gun and pump and start engine.
11
Tabla de contenido
