Cherubini TDS GOLD Serie Manual De Instrucciones página 28

TEST MODE FOR WINDTEC/WINDTEC LUX
This function is useful to check the correct communication via radio, and perform the wind
and sun function test.
To activate the TEST function, hold the SET button down for around 2 seconds, until the
awning opens for 10 seconds and closes briefly to confirm that the test mode is activated.
The Test function lasts for 3 minutes, during which the wind and light level settings can
be checked, without waiting for the activation times. After 3 minutes, the WindTec sensor
returns to normal mode function.
set
2 sec
WIND FUNCTION TEST (WINDTEC, WINDTEC LUX)
To avoid errors during the wind function test, we advise to turn off the sun-sensor. With
the anemometer blades moving, when the speed detected by the sensor exceeds the set
level, the motor will close completely the awning.
SUN FUNCTION TEST (WINDTEC LUX)
Check that the sun-sensor is active. When the sensor detects a change in light intensity,
it opens the awning if brighter than the set point or closes it if weaker. This test can
be repeated several times to establish the desired automatic opening and closing level
according to the light.
GB
28