Operation - Steren K-835 Manual De Instrucciones

OPERATION

It is recommended two persons for assemble.
It is recommended to solder wire tips before solder to PCB.
POT1 value could be 50K or 100K.
Diodes 1N5819 could be also 1N5818 or 1N5817.
1. Prepare LEDs and POT soldering 10 cm of wires to their pins,
on LEDs red for positive and black for negative, on the POT use
white wires.
2. Solder resistors and diodes on the PCB, ATTENTION with
diodes nomenclature and polarity.
3. Bend Q1 transistors pins and solder it, it must be laid.
4. Solder battery wires, LEDs and POT paying attention to position
and polarity indicated on the PCB.
5. Solder electrodes wires, black both of 1 meter lenght, make a
knot at 5 cm from the end in order to use it as a stopper.
6. Solder transformers wires letting enough wire lenght in order to
pass over the batteries, it is necessary to cut red and black wires
only.
8