Using The Remote Control; Installing Batteries; When To Replace Batteries - Tascam 202 MKVII Manual Del Usuario

M
MIC connector and mic LEVEL knob
When using a mic to record, insert the mic cable plug into this
connector and turn the knob to a suitable level (page 21) .
o This unit does not support stereo mics . Use a mono mic .
o When a mic is connected, the tape playback level is lowered
slightly . When the mic is disconnected, the playback level
will return to normal .
N
REC LEVEL (recording level) knob
Use to adjust the recording level .
O
PHONES jack/LEVEL knob
Plug headphones into this jack to use them with this unit .
Sound will be output from the LINE OUT jacks even when
headphones are plugged in here .
Use the LEVEL knob to the left to adjust the headphone
volume .
V
CAUTION
While wearing headphones, do not connect or discon-
nect them or turn the unit on or off. Doing so could result
in a sudden loud noise that could harm your hearing.
P
TIMER switch
Use this switch to set the timer setting mode (record, off or
play) . Leave this switch in the OFF position for normal use .
To use timer playback/recording, connect a commercially-avail-
able timer to this unit (page 26) .
Q
NOISE REDUCTION switch
This function reduces hiss during tape playback .
o It only functions during playback .
o Using this during playback of tapes recorded with Dolby B
noise reduction will reduce hiss . This cannot be used when
recording to achieve a noise reduction effect like Dolby B .
R
PLAY MODE switch
Use this switch to enable the SPECIAL playback mode using the
double cassette deck (page 29) .

Using the remote control

Precautions for use
V
Misuse of batteries could cause them to rupture
or leak, which might result in fire, injury or the
staining of nearby materials.
Please carefully read and observe the precau-
tions on page 3.
o When using the remote control, point it toward the remote con-
trol signal receiver on the main unit from a distance of 5 m (16 ft)
or less . Do not place obstructions between the main unit and the
remote control .
o The remote control might not work if the remote control signal
receiver on the unit is exposed to direct sunlight or bright light . If
this occurs, try moving the unit .
o Beware that use of this remote control could cause the unin-
tentional operation of other devices that can be controlled by
infrared rays .

Installing batteries

Remove the cover from the back of the remote control and insert
two AA batteries with their ¥/^ oriented as shown in the case .
Replace the cover .

When to replace batteries

If the distance required between the remote and the main unit
decreases or if the unit stops responding to the remote buttons,
replace both batteries with new ones . Dispose of the used batteries
according to the instructions on them or requirements set by your
local municipality .
11