Connection Example - Kenwood KCA-S220A Manual De Instrucciones

Connection
Connectable Control Units and Disc Changer/Disc Player Units
7 Connectable Control Unit
Group A: This group covers control units with disc changer control, where the source selection allows you
to switch between 1 and 2, where the manual instructs you to set the O-N switch on the disc
changer to "N".
Group B: This group covers units released on to the market in or after 1999, where the manual covers AUX
mode under switching sources.
7 Connectable Disc Changer/Disc Player Units
Disc changer/disk player units released on to the market in or after 1999.
• Any control unit and disc changer/disc player unit other than those above cannot be connected. If connected, the
switching unit can be out of order or damaged.
• If the disc changer/disc player unit you have connected has an O-N switch, set it to the "N" position.
Components
! Switching unit..................................................1
" Connection cable (2 m)..............................1

Connection Example

Control unit
CD changer
• After connecting the equipment, press the reset button on the control unit.
• The figure shows that one CD changer and one MD changer are connected. Two CD changers or two MD changers may be
connected.
• A disc player such as the KDC-D301 or KCA-iP500 (etc.) may be connected instead of the disc changer.
2
KCA-S220A
Changer control output
Connection cable "
Connection cable (supplied with the CD changer)
Connection cable (supplied with the MD changer)
# Velcro strip..........................................................2
$ Self-tapping screw (φ 4 × 16 mm).......2
To the external unit
AUX IN
TO HEAD UNIT TO CHANGER 1
TO HEAD UNIT TO CHANGER 1 TO CHANGER 2
MD Changer
Switching unit !
(Rear side)
TO CHANGER 2
Switching unit !
(Front side)