Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English / USA
To reduce the risk of fire and burn
injury, use only spark plugs
authorized by STIHL. Always press
spark plug boot (2) snugly onto
spark plug terminal (1) of the proper
size. (Note: If terminal has
detachable SAE adapter nut, it must
be attached.)
A loose connection between spark
plug boot and ignition wire
connector in the boot may create
arcing that could ignite combustible
fumes and cause a fire.
22
Lubricating the
Gearbox
1
Use STIHL gear lubricant for hedge
trimmers (see "Special Accessories") to
lubricate the blade drive gear.
After about 25 hours of operation:
:
Remove the screw plug (1) from the
gear housing.
:
Screw the tube of grease (2) into the
filler hole.
:
Roll up the end of the tube to the
next division on the scale. This
forces about 3/4oz (20g) grease into
the gearbox.
:
Refit the screw plug and tighten it
down firmly.
Rewind Starter
To help prolong the wear life of the
starter rope, observe the following
points:
:
Pull the starter rope only in the
direction specified.
:
Do not pull the rope over the edge of
the guide bushing.
:
Do not pull out the rope more than
specified since it might break.
:
Do not let the starter grip snap back,
guide it slowly into the housing.
See also chapter "Starting /
Stopping the Engine"!
Have a damaged starter rope
replaced in good time by your
servicing dealer.
HS 81 R, HS 81 T
Capítulos
Tabla de contenido
