Ice Maker Door Reversal-Side Swing Only - Kenmore 106.8955 Serie Manual De Uso

Ice Maker Door Reversal—Side Swing Only
Tools Needed
Gather the required tools and parts before starting installation.
⁵⁄₁₆ " wrench
¹⁄₄ " wrench
Hinge pin
Handle screw
Remove Exterior Door Wrap and Handle
(on some models)
A. Hex-head screws
1. Remove the handle screws and handle (on some models).
2. Remove the 2 hex-head screws located under the stainless
steel door wrap panel flange on the bottom of the door.
3. Pull up and outward on the door wrap panel from the
bottom.
4. Rotate the door wrap panel until it separates from the door
and pull up.
NOTE: Be sure the edge guards do not separate from the
door wrap panel.
Flat putty knife
Phillips screwdriver
⁵⁄₁₆ " hex-head hinge screw
End cap screw
A
Door Stop and End-Cap Reversal
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Unplug the ice maker or disconnect power.
2. Remove the hinge pin from the top hinge.
Top Hinge
A. Hinge pin
B. Phillips-head countersink screw
C. Door stop
Bottom Hinge
E
A. Hex-head hinge screw
B. Door stop
C. Phillips-head countersink screw
A
B
C
D
E
D. Hinge
E. Hex-head hinge screw
A
B
C
D
D. Hinge pin
E. Hinge
11