Remaining Risk Factors; Assembly; Preparatory Activities; Work Area - HOLZMANN MASCHINEN WP 10H Manual De Instrucciones

 Keep your work area dry and tidy! An untidy work area may cause accidents. Avoid
slippery floor.
 Make sure the work area is lighted sufficiently
 Provide good stability and keep balance all times
 Do not use the machine outdoors
 Always stay focused when working. Reduce distortion sources in your working
environment. The operation of the machine when being tired, as well as under the
influence of alcohol, drugs or concentration influencing medicaments is forbidden.
 Do not climb onto the machine!
 Attach the machine to the underground
 Respectively trained people only and only one person shall operate the machine.
 Do not allow other people, particularly children, to touch the machine or the cable.
Keep them away from your work area.
 Make your workshop childproof.
 Wear suitable work clothes! Do not wear loose clothing or jewelry as they might get
caught in moving parts and cause severe accidents! Wear a hair net if you have long
hair.
 Use personal safety equipment: ear protector, safety goggles and safety gloves when
working with the machine.
 Do not exceed in any case the max. pressing force of the shop press.
 Make sure that the workpiece surface, the stamp and the workpiece are free of
lubricants and generally in a clean and dry condition.
 Use the Workshop Press exclusively on a solid, stable, level and non-slippery surface!
 Keep hands and feet away while operating from the working area of the pressure
stamp.
 Use only high-quality hydraulic oil with the addition or replacement of oil.
 Open before operating the ventilation screw (11) by 4 pitches. Close after operation.

10.4 Remaining risk factors

Also in compliance with all safety regulations and when used properly, the following residual risks
must be observed:
• Risk of injury by tilting the machine.
• Danger of injury due untrimmed drilling edges, edges of the workpiece.
• Risk of injury, particularly to the eye by flying parts of the workpiece.
These risks can be minimized if all safety rules are applied, the machine is properly maintained
and serviced the machine as intended and is serviced by a trained service professional. Despite
all the safety devices and remains her good common sense and your corresponding technical
suitability / training on the prudent operation of a machine like the WP 10H / 12H WP / WP 20H of
the most important safety factor!

11 ASSEMBLY

11.1 Preparatory activities

11.1.1 Work area

Choose a suitable place for the machine;
Observe the safety requirements of Chapter 10 and the dimensions of the machine from the
technical details.

11.1.2 Preparation of the surface

Uncoated metal machine parts have been insulated with a greasy layer to inhibit corrosion.
This layer has to be removed. You can use standard solvents that do not damage the machine
surface.
Do not use solvents based on nitrite, aggressive solvents like break
cleaners or scrubbing agents!
These damage the machine surface.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
N O T I C E
ASSEMBLY
15
WP 10H/WP 12H/WP 20H