SEVERIN BA 3253 Instrucciones De Uso página 11

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
should be adjusted to 'iron dry' . Very dry
fabrics are diffi cult to iron.
Start up
Clean the iron before using for the fi rst
time, according to the instructions given in
the paragraph 'General Care and Cleaning
- Self-cleaning system' . Th is will result in
the removal of any dust particles from the
soleplate and subsequently lessen the smell
typically encountered when fi rst switching
on.
Please ensure suffi cient ventilation.
Ironing
Always use the iron on a heat-resistant
surface.
Steam ironing requires high temperatures.
Th e temperature level for steam ironing
is indicated on the temperature control
knob.
Aft er fi lling the reservoir with water, place
the steam iron upright on its base stand
and insert the plug into the wall socket.
Set the temperature control knob to the
required ironing temperature as indicated
by the ironing symbols.
During the heating-up process, the
indicator lamp on the temperature selector
will be on. Th e lamp will go out once the
required temperature is reached. Th e main
indicator lamp in the handle remains lit as
long as the appliance is connected to the
mains power.
Before ironing any fabric, the soleplate
should be cleaned by passing it over an
old, clean cotton cloth while using the
steam jet function; this helps to fl ush out
any dirt residues or lint particles trapped
inside the openings in the soleplate.
Th e steam output can be adjusted with
the steam control button, or switched off
completely for dry ironing.
For dry ironing, the water reservoir may
be left empty. But if there is any water left
in the reservoir, the steam jet function
may also be used when dry-ironing at
higher temperature settings.
Place the steam iron upright on its base
stand aft er use and remove the plug from
the wall socket.
Automatic switch-off
If the appliance is switched on but has not
been used for a certain period of time, it
will automatically switch off . Th is automatic
switch-off is indicated by a beep signal; in
addition, the main indicator lamp in the
handle fl ashes. Th e automatic switch-off is
indicated by a beep signal; in addition, the
red indicator light fl ashes. As soon as the iron
is moved, it will switch itself on again.
Horizontal position:
When resting on its sole plate, the iron
will switch off aft er approx 30 seconds of
inactivity.
Vertical position:
When standing upright on its base, it will
switch off aft er approx. 10 minutes.
Steam jet from underside and tip of
soleplate
When the steam jet button is depressed, an
additional hot steam jet is emitted from the
underside and the tip of the soleplate. Th is
function can be very useful when the normal
amount of steam emitted is not suffi cient to
remove stubborn creases, or when ironing
diffi cult or thick fabrics.
Th e steam jet button can also be used for
diffi cult or hard-to-reach areas such as collars,
cuff s, pockets and around buttons. Th e steam
jet emitted from the tip of the soleplate makes
ironing easier and faster.
For optimum steam output, wait about 4
seconds before using this function again.
Th e steam jet function may also be used with
the iron held vertically, to remove creases or
wrinkles from fabrics.
Note:
For a more powerful steam jet, set the steam
control to 'dry ironing' .
11
loading

Este manual también es adecuado para:

Ba 3252Ba 3210