SEVERIN FM 7631 Instrucciones De Uso página 11

nails, place your feet on the middle pad.
- If the aroma function is required, pull out
the nail-dryer insert from the main unit.
Add a few drops of scented oil to the
sponge inside the aroma chamber, then
slide the nail-dryer insert back into the
main unit until it locks into place.
- Switch off the foot massager after use.
Pedicure unit
Batteries
This pedicure unit requires 2 type AA / 1.5
V batteries; the use of alkaline batteries is
preferable, as they last longer than standard
carbon-zinc batteries. The batteries are
inserted as follows:
- Slide the battery compartment cover in
the direction indicated by the arrow and
take it off.
- Insert the batteries according to the
schematic diagram
compartment, ensuring correct polarity
(+/-).
- Replace the compartment cover and
slide it back until it is heard locking into
place.
●
A significant decrease in operating speed
is a clear indication that the batteries are
exhausted, and that they should be
replaced.
●
Always remove the batteries from the
pedicure unit during extended periods of
non-use. This will prevent damage to the
appliance from leakage.
●
Never dispose of old batteries in your
domestic garbage. Old batteries must be
disposed of through local 'special
garbage collection points'.
Using the pedicure unit
With the appliance switched off, fit the
attachment required onto the front of the
pedicure unit and push it in as far as it will
go.
- Sponge attachment: for polishing toe
nails.
- Abrading attachment: for shortening and
- Cleaning brush: for cleaning the nails
- Filing attachment: for filing and other
The slide-switch on the pedicure unit allows
for two different speed settings.
The feet should be treated after a hot bath
or shower, as calluses and nails will be
softened in this way.
Always switch the pedicure unit off after use.
A decrease in operating speed indicates low
battery capacity. When this occurs, switch off
the pedicure unit and replace the batteries.
Cleaning and care
●
●
inside the
●
Foot massager
- The inside and the exterior of the foot
Pedicure unit
- The exterior of the pedicure unit may be
- The inserts may be cleaned as necessary
Disposal
11
shaping toe nails.
after filing, and for removing skin
particles remaining after the treatment. It
is also useful for preparing the nail
surfaces for polishing.
treatment of the nail surfaces.
Before cleaning the appliance, ensure it is
disconnected from the power supply.
To avoid the risk of electric shock, do not
clean the housing of the foot massager
with water and do not immerse it in
water.
Do not use abrasives or harsh cleaning
solutions.
massager may be cleaned with a slightly
damp lint-free cloth. Use household
tissue paper to wipe dry afterwards.
Special, commercially available cleaning
agents for synthetic materials may also be
used for cleaning.
wiped with a dry cloth.
with an alcohol solution.
Do not dispose of old or defective
appliances in domestic garbage;
this should only be done through
public collection points.