Replacing The Plug Fuse (12/24 V); Cleaning And Maintenance - Dometic CDF Serie Instrucciones De Uso

Cleaning and maintenance

7.9

Replacing the plug fuse (12/24 V)

➤ Pull the adapter sleeve (fig. 7 4, page 4) off of the plug.
➤ Unscrew the screw (fig. 7 5, page 4) out of the upper half of the housing
(fig. 7 1, page 4).
➤ Carefully raise the upper half of the housing from the lower (fig. 7 6, page 4)
half.
➤ Take out the contact pin (fig. 7 3, page 4).
➤ Replace the defective fuse (fig. 7 2, page 4) with a new one that has the same
rating (8A 32V).
➤ Re-assemble the plug in the reverse order.
I
NOTE – Internal DC fuse
There is an additional DC fuse inside the device (Automotive standard
blade fuse, 10 A). This fuse can only be replaced by an authorised repair
centre.
7.10 Replacing the light bulb (CDF26, CDF36, CDF46)
➤ Press the switch pin (fig. 8 2, page 4) downwards so that the transparent part
(fig. 8 1, page 4) of the lamp can be removed at the front.
➤ Replace the light bulb.
➤ Press the lamp back into the housing.
8 Cleaning and maintenance
!
WARNING! Electrocution hazard
Always disconnect the device from the power supply before you clean
and service it.
A
NOTICE! Risk of damage
• Never clean the cooler under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooler.
➤ Occasionally clean the device interior and exterior with a damp cloth.
18
CoolFreeze
EN