Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Trouble-shooting
Certain typical sounds can be heard when the appliance is switched on. These sounds are caused by:
–
the electric motor within the compressor assembly; during
compressor start-up the sound level will be slightly higher for a
short time.
–
the cooling agent flowing through the circuit.
The following table lists possible malfunctions, their probable causes and solutions. In the event of
operational problems, check first whether a solution can be found using this table. If the problem
persists, disconnect the appliance from the mains power and contact our Customer Service
Department.
Problem
The appliance is connected to the
mains but fails to operate properly.
Abnormal noise can be heard during
operation.
When opening the door, the rubber
seal pops out.
Water collects on the bottom of the
cabinet.
Transporting the appliance
The unit must be transported only in its vertical position.
Do not tilt it any more than 30°. During transport, ensure that the unit is properly secured and
protected against shock, vibration and shifting.
Disposal
This appliance has been manufactured from recyclable materials. After removing the plug
from the wall socket, the unit should be rendered unusable by cutting off the power cord
before being disposed of through special waste collection points in accordance with local
regulations. The refrigerant and the chemical agent in the insulation foam must be disposed of
through a competent agency. Take special care not to damage the cooling circuit before the unit is
handed over for competent disposal.
Guarantee
This product is guaranteed against defects in materials and workmanship for a period of two years
from the date of purchase. Under this guarantee the manufacturer undertakes to repair or replace
Possible cause and solution
The wall socket has no power, or there are contact
problems. Check the wall socket and the plug.
Either the unit has been improperly set up (e.g. on an
uneven floor) or there is contact between the rear-mounted
cooling circuit and the power cord, the wall or other object
or surface. Verify that all installation instructions in this
manual have been complied with.
The seal must be re-fitted properly, by pressing in the inner
part of the seal. If the seal shows signs of a greasy residue,
the seal and the door must be properly cleaned with water
and a mild detergent, and then thoroughly dried before the
seal is replaced on the door.
The melt-water drain system is blocked. Remove blockage
and clean the drain system.
13
Tabla de contenido
