SEVERIN KS 9878 Instrucciones De Uso página 11

∙ Clean the unit according to the instructions given in the De-
frosting and cleaning section below.
∙ For positioning, we recommend that you tilt the unit slightly
backwards. In this way, the transport rollers can be used to
move it to its intended place of installation.
∙ The unit should only be transported in its vertical position;
do not tilt any more than 30°.
∙ Once the unit has been positioned, wait for about 30
minutes before it is connected to the mains.
∙ If the unit has been tilted more than 30° during transport,
allow it to stand upright for at least 4 hours before it is
connected to the mains.
∙ When the unit is fi rst switched on, a slight 'new' smell may
be noticed. However, this will disappear once the cooling
process has begun.
Installation
∙ The appliance should be set up in a well-ventilated, dry room.
∙ It should be operated in conditions where the relative humidity
is no more than 60 %.
∙ The product data sheet contains details of the ambient
temperature range suitable for this appliance.
∙ Do not use the appliance outdoors.
∙ Ensure that the plug is accessible and can be removed from the
wall socket at any time.
∙ Do not expose the appliance to direct sunlight, and do not
position it next to any heat sources (radiators, cookers etc). If
this cannot be avoided, however, suitable insulation must be in
installed between the heat source and the unit.
∙ The unit must not be installed inside a cabinet, nor directly
below a hanging cupboard, shelf or similar object.
∙ If the unit is installed next to a wall, a minimum lateral distance
of 10 mm is necessary for the door to fully open.
∙ If the fl oor is uneven, the adjustable feet on the unit can be
used to compensate and ensure optimum stability.
Set-up dimensions
Warning: Take special care that the ventilation openings
in the upper part of the rear panel are not blocked or
obstructed.
Temperature control
∙ The unit is activated by connecting it to the mains. It is only
switched off completely when the plug is removed from the
wall socket.
∙ The green mains indicator light shows that the unit is
connected to the mains.
∙ The temperature in the refrigerator cabinet can be adjusted
by setting the temperature control (0-5). Turning the control
clockwise will decrease the temperature, while turning it anti-
clockwise will increase it.
∙ The temperature can be set within a 0 to 10°C range.
∙ The temperature in the cabinet largely depends on factors
such as the ambient temperature, the setting and the
number of bottles stored.
∙ We recommend using a thermometer to check the actual
temperature inside the cabinet and make adjustments as
necessary.
∙ Always ensure that the door is properly closed and that the
seal is not obstructed by bottles stored inside the cabinet.
∙ Following a power interruption, or if the unit has been
switched off on purpose, it may take 3 to 5 minutes before it
switches on again.
∙ Note: With the temperature control in position '0', only
the compressor is switched off, while the fan is still
running.
Ventilation
The heated air around
the rear of the unit must
be able to circulate freely.
Therefore, ensure that
the air circulation is not
obstructed.
11