Idiomas disponibles
Idiomas disponibles
following the relevant instructions. Allow
the generator to cool down for about 30
minutes, after which the appliance is ready
for use again.
General information about ironing
Always check first whether a label with
ironing instructions is attached to the article
to be ironed.
- The meaning of the ironing symbols is as
follows:
•
synthetics
(low temperature)
••
silk and wool
(medium temperature)
•••
cotton and linen
(high temperature)
- These markings can also be found on the
temperature control knob of the iron in
the form of dot symbols.
●
Laundry to be ironed should be sorted
according to the fabric ironing
temperature. Follow the ironing symbols
and start with the lowest temperature.
●
When ironing highly sensitive fabrics, or
if you are not sure about the fabric,
carefully test-iron on a non-visible point,
e.g. inside a seam. Always start with the
lowest temperature.
●
If the laundry is put into a dryer before
ironing, the temperature should be
adjusted to 'iron dry'. Very dry fabrics
are difficult to iron.
Start up
Before it is used for the first time, the iron
should be cleaned according to the
instructions given in the paragraph General
Care and Cleaning. This will remove
possible dust particles from the sole plate
and subsequently lessen the smell typically
encountered when first switching on.
Ensure sufficient ventilation.
Steam regulator
The steam regulator is used to adjust the
steam output.
Before using the steam jet function, turn the
steam regulator to its max position. Steam
will be emitted after 40-60 seconds. Now set
the regulator to the desired position.
The main indicator light (for the pump)
comes on whenever the steam jet button or
the steam button is pressed.
Ironing
●
Steam
ironing
temperatures. The temperature level for
steam ironing is indicated on the
temperature control knob.
- Fill the water reservoir with clean tap
water.
- Place the iron on its rest and insert the
plug into a suitable wall socket.
Use the On/Off switch to turn the steam
generator on. The indicator light on the
switch comes on.
- Set the temperature control knob to the
required ironing temperature according
to the ironing symbols.
- As the iron is heating up, the indicator
lamp on the iron will be on. It goes out
once the required ironing temperature is
reached.
●
Before starting to iron, the sole plate
should be cleaned by passing it over a
clean cotton cloth, while using the steam
jet function; this helps to flush out any
dirt residues or lint particles trapped
inside the openings in the sole plate.
●
For dry ironing, the water reservoir can
be left empty.
●
When the steam jet button or the steam
button is depressed, the sound of the
pump increases, as residual air is pumped
out of the boiler. When using the steam
jet function, first turn the steam regulator
to its max position. Steam will be emitted
after 40-60 seconds.
- Use the steam regulator to select the
required steam output.
- You can now start ironing.
●
If, during ironing, the water reservoir
becomes empty, simply re-fill it as
described in the section 'Filling with
water'. Always replenish the water in
11
requires
high
