Bosch GDC 14-40 Manual De Instrucciones página 13

Initial operation
Be careful of hidden electrical lines or gas and
water pipes. Check the working area, e.g. with a
metal detector.
This tools was developed only for horizontal cut-
•
ting. Do not use it for cutting wall or ceiling.
Check for the correct mains voltage:
voltage of the power source must agree with
the voltage specified on the nameplate of the
machine. Equipment marked with 127 V can be
use to 115 V.
SWITCHING ON AND OFF
Intermittent switching
ON - 2
Push trigger .
OFF -
Release trigger.
Continuous switching
ON - 2
Press trigger and button
lease them.
OFF -
Press and release trigger
Operating instructions
Wear protective goggles, ear protection and a dust
protection mask.
Wear protective gloves and protective shoes.
Clamp the workpiece if it does not remain station-
•
ary due to its own weight.
Do not load the machine so heavily that is comes
•
to a standstill.
Caution!
Diamond cutting discs become very hot dur-
ing operation; do not touch them before they have cooled
down.
When cutting, do not press, tilt or oscillate. Work with
moderate advancing that is adapted to the material be-
ing worked.
Do not brake coasting cutting disks with side pressure.
CUTTING DIRECTION (fig. D)
Important is the direction in which cutting is per-formed.
The machine must always operate in the reverse sense;
therefore, only push the machine forwards! Otherwise
there is a danger of it being pressed out of the cut in an
uncontrolled fashion.
8
The cutting mark shows the position of the diamond cut-
ting disc for a right-angled cut.
A dull diamond grinding disc can be sharpened in abrasive
material (e. g., chalky sand stone).
The
3
at one time then re-
2
.
Maintenance and cleaning
Before any work on the machine itself, pull the
mains plug.
For safe and proper working, always keep the ma-
chine and the ventilation slots clean.
If the machine should fail despite the rigorous manufac- turing and testing procedures, repair should be carried
out by an authorized customer services center for Bosch
power tools.
Guarantee
We guarantee Bosch appliances in accordance with
statutory/country-specific regulations (proof of purchase
by invoice or delivery note).
Damage attributable to normal wear and tear, over-load or
improper handling will be excluded from the guarantee.
In case of complaint please send the machine,
tled
, to your dealer or the Bosch Service Center for Elec-
tric Power Tools.
Warning!
Freight and insurance costs are charged to the client, even
for warranty claims.
Environmental protection
Recycle raw materials instead of dispos-
ing as waste.
The machine, accessories and packaging
should be sorted for environmental-friendly
recycling.
The plastic components are labeled for categorized re-
cycling.
undisman-
9