Idiomas disponibles
Idiomas disponibles
Conversion from LP Gas to
Natural Gas
Orifice Change and the Installation of the NG regulator
1.
Turn off the main gas supply valve.
2.
Disconnect 20 lb LP gas fuel tank (if present).
3.
Turn off burner control valve.
4.
Use screwdriver to remove screw holding the corrugated
pipe connector to the enclosure.
5.
Use adjustable wrench to remove hose and regulator from
corrugated pipe connector.
6.
Remove side searing burner cooking grid.
7.
Use a screwdriver to remove one screw from ignitor pin
and two screws on the rear of the side searing burner.
8.
Lift the burner starting from the back, as shown.
9.
Use 6 mm socket wrench or 6 mm nut driver to remove the
orifice.
10. Replace with natural gas orifice.
11. Reinstall sear burner. Tighten the sear burner orifice brass
connector and sear burner tube by using a wrench.
IMPORTANT: Check that the orifice is properly installed
inside of the side searing burner gas valve.
19
