Idiomas disponibles
Idiomas disponibles
Customer Responsibilities
Check Safety Valve
Drain Tank
cycles automatically when power is
on. When servicing, you may be
exposed to voltage sources,
compressed air, or moving parts.
Before servicing unit unplug or
disconnect electrical supply to the
air compressor, bleed tank of
pressure, and allow the air
compressor to cool.
NOTE: See "Operation" section for
the location of controls.
To Check Safety Valve
does not work properly, over-
pressurization may occur, causing
air tank rupture or an explosion.
1.
Before starting compressor, pull
the ring on the safety valve to
make sure that the safety valve
operates freely. If the valve is
stuck or does not operate
smoothly, it must be replaced
with the same type of valve.
MAINTENANCE
Before
each
use
Risk of Unsafe
Operation. Unit
Risk of Bursting. If
the safety valve
Daily or
after
each
use
●
●
To Drain Tank
1.
Set the On/Auto/Off lever to
"OFF".
2.
Turn the regulator knob counter-
clockwise to set the outlet
pressure to zero.
3.
Remove the air tool or
accessory.
4.
Pull ring on safety valve allowing
air to bleed from the tank until
tank pressure is approximately
20 psi. Release
safety valve ring.
5.
Drain water from
air tank by opening
drain valve on
bottom of tank.
tank. If not drained, water will
corrode and weaken the air tank
causing a risk of air tank rupture.
6.
After the water has
been drained,
close the drain
valve. The air
compressor can
now be stored.
NOTE: If drain valve is plugged,
release all air pressure. The valve
can then be removed, cleaned, the
reinstalled.
15- ENG
Open Drain
Valve
Water will
condense in the air
Closed Drain
Valve
D30052
