Installation Instructions
C4
MOUNT THE OVEN (continued)
Insert 2 self-aligning screws
(Ya"-28 x 3Y4") through outer
top cabinet holes. Turn two full
turns on each screw.
screw completely.
NOTE: Use self-aligning screw, %"-28 x 2%8", on
PVM1790 and self-aligning screws, Y"-28 x 3%",
on PSA1200 and PSA2200.
|7 | Tighten the outer two screws to the top of the
oven. (While tightening screws, hold the oven
in place against the wall and the top cabinet.)
Install grease filters. See the Owner's Manual
packed with the oven.
22
C5
INSTALLING THE CHARCOAL
FILTER
Remove 2 screws on top of oven, just above
the grille panel, using a Phillips screwdriver.
Open the door.
Remove the grille.
Grille
Insert the filter into the oven as shown until it fits
squarely into place. It will rest at an angle behind
the front lower tabs. When properly installed,
the wire mesh of the filter should be visible
from the front.
Charcoal filter installed
Replace the grille and the 2 top screws.
[6 | Close the door and replace left side screw.