Idiomas disponibles
Idiomas disponibles
BEFORE USING FOR THE FIRST TIME
1.
Fill the reservoir to the max mark, and run the appliance without coffee.
2.
Let it cool, discard the water, then use it normally.
FILLING
1.
Remove the carafe from the hotplate.
2.
Use the grip to open the lid, and expose the reservoir.
3.
Fill with at least 2 cups of water, but not above the max mark.
4.
Open up a #4 paper filter, and put it into the filter holder.
5.
Put filter-ground coffee into the filter. The amount will vary with the type of coffee and individual
taste, but we suggest two rounded teaspoons per cup of water.
6.
Close the lid.
7.
Replace the carafe on the hotplate.
SWITCH ON
1.
Put the plug into the power socket.
2.
The display will light up.
COFFEE NOW
1.
Ignore the clock.
2.
If you're making less than 5 cups of coffee, press the Y button, to turn the brew strength feature on.
a will appear on the display.
3.
It slows the brewing process, so your coffee will have the same strength as coffee from a full carafe.
4.
You may hear the switch operating as it does this.
Press the X button. The X light will glow.
5.
6.
Shortly afterwards, coffee will start to drip into the carafe.
COFFEE LATER
1.
The clock will retain its settings until the coffee maker is unplugged.
2.
The display will show AM for morning, and PM for afternoon.
Check that the X light is off. If it isn't, press the X button to turn it off.
3.
4.
Set the clock to the correct time.
a)
Press the h/min button, and keep it pressed till the display flashes (2 seconds).
b)
Press and release the h/min button until the correct hour is shown.
Press and release the T button – the minutes side of the display will flash.
c)
d)
Press and release the h/min button until the correct minute is shown.
e)
Leave the controls for 5 seconds to confirm the time.
5.
Set the timer to the time you want to start brewing.
Press and release the T button. The display will show – : – –
a)
Press and release the h/min button until the correct hour is shown.
b)
Press and release the T button – the minutes side of the display will flash.
c)
d)
Press and release the h/min button until the correct minute is shown.
e)
Leave the controls for 5 seconds to confirm the time.
If you don't press the h/min button within 5 seconds, the display will revert to "normal", and the time will
show. Press the T button, and start again.
ACTIVATION
1.
If you're making less than 5 cups of coffee, press the Y button, to turn the brew strength feature on.
a will appear on the display.
2.
Press and release the Z button.
3.
The Z light will come on, and Z will show on the display.
When the set time is reached, the Z light will go off, the X light will come on, Z will disappear from
4.
the display, and brewing will start.
5.
If you want to cancel the timer before brewing has started, press the Z button.
3
