Idiomas disponibles
Idiomas disponibles
27
28
A
A
30
Rear Wheel Dolly/Tool Holder And Front Caster Feet Assembly
(Not standard with all models)
You will find two casters (Figure 32), two large rear wheels (Figure 33), one axle (Figure
34), rear dolly/basket (Figure 35), two caster feet (Figure 36), four screws (Figure 37), two
washers (Figure 38), two hair pin clips (Figure 39). If your vacuum is 16 U.S. gallons (60.5
liters) or larger you will also find two screws, two metal flat washers and two square nuts with
your wet/dry vacuum. Assemble as follows:
32
33
35
36
38
Assemble as follows:
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down so
that the bottom is facing up.
2. Place one hair pin clip in one end of axle (Figure 40). Slide one washer down the length of
the axle to rest on the hair pin clip. Slide wheel onto axle next to washer (Figure 41). Be
sure flat side of wheel hub is facing outward.
3. Slide axle through holes provided in dolly/basket (Figure 42).
4. Slide remaining wheel then washer onto axle. Insert hair pin clip into remaining hole in axle
to hold wheel in place (Figure 43).
5. Take rear dolly assembly and place into slots (on rear of tank opposite drain) and secure
with screws provided (Figure 44).
6. With tank drain facing you, take caster foot marked with the letter A (Figure 45) and place
in slot on left side of tank also marked with the letter A and secure with screw provided
(Figure 46).
7. Take caster foot marked with the letter B (Figure 47) and place in slot on right side of tank
also marked with the letter B and secure with screw provided (Figure 48).
8. Insert casters into feet by placing stem of caster into holes provided. Apply pressure and
twisting motion until casters snap into place (Figure 49).
9. Return tank to upright position.
40
41
29
B
A
31
34
37
39
42
43
B
45
48
(Not standard with all models)
If your tool holder looks like the one pictured in Figure 50, follow these instructions.
1. With rear of unit facing you, take tool holder and position it with tabs facing rear of unit
(Figure 51).
2. Place "J" shaped tabs into the slots on cord wraps (Figure 52).
3. Press down until tabs snap into place.
4. Press down on center of tool holder until tab latches on bottom lid (Figure 53).
If your tool holder looks like the one pictured in Figure 54, follow these instructions.
1. With rear of unit facing you, take tool holder and slide over notches on rear of tank (Figure
55).
50
53
INSTALLING THE CARRIAGE HANDLE
(Not standard with all models)
Stand vacuum right side up. Place metal carriage handle
outside of tank and under the side carrying handles. Be sure
to spread the ends of the carriage handles when assembling
to prevent damage to the tank. Align holes of carriage
handle to holes in tank and fasten tightly with screws,
washers, and nuts provided. The sealing washer and screw
have a close fitting tolerance. Rubber side of sealing washer
should fit against inside wall of tank. Failure to properly
install rubber washer could result in water leakage or loss
of performance. Replace the tank cover and clamp the lid
latches securely.
INSTALLING FOAM SLEEVE AND
REUSABLE DRY FILTER
(Not standard with all models)
WARNING
44
46
47
A
49
TOOL HOLDER
51
52
54
55
Carriage
Handle
Hex Head
Locknut
DRY PICK UP
– ALWAYS DISCONNECT THE PLUG FROM THE
Sealing
Washer
Screw
