VALBERG 6S47 D SAD929C Instrucciones De Uso página 9

Ocultar thumbs Ver también para 6S47 D SAD929C:
Idiomas disponibles

Idiomas disponibles

B
Product usage
WARNING
A hose that attaches to tap can burst if it is installed on the same water line as the
dishwasher. If your sink has one, it is recommended that the hose be disconnected
and the hole plugged.
How to connect the safety supply hose
1.
Pull the safety supply hoses out from storage compartment located at rear of dishwasher.
2.
Tighten the screws of the safety supply hose to the faucet with thread 3/4inch.
3.
Turn the water fully on before starting the dishwasher.
How to disconnect the safety supply hose
1.
Turn off the water.
2.
Unscrew the safety supply hose from the faucet.
Connection of drain hoses
Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run into the
sink, making sure to avoid bending or crimping it. The height of drain pipe must be less than
600 mm. The free end of the hose must not be immersed in water to avoid the back flow of it.
WARNING
Please securely fix the drain hose in either position
Back of dishwasher
Mains Cable
Drain pipe
Inlet pipe connector
Drain pipe
8
EN
or position
.
Drain Pipe
40 mm
Counter
loading

Este manual también es adecuado para:

6s47 d wad929c988234988225