VALBERG 6S47 D SAD929C Instrucciones De Uso página 32

C
Cleaning and maintenance
Troubleshooting tips
Before calling for service
Reviewing the charts on the following pages may save you from calling for service
Problem
Dishwasher
doesn't start
Water not pumped
from dishwasher
Foam in the tub
Stained tub interior
Possible Causes
• Fuse blown, or
the circuit breaker
tripped.
• Power supply is not
turned on.
• Door of dishwasher
not properly closed.
• Kink in drain hose
• Filter clogged.
• Kitchen sink
clogged.
• Improper detergent.
• Spilled rinse aid.
• Detergent with
colourant may have
been used.
31
Solution
• Replace fuse or reset circuit breaker.
• Remove any other appliances sharing
the same circuit with the dishwasher.
• Make sure the dishwasher is turned
on and the door is closed securely.
• Make sure the power cord is properly
plugged into the wall socket.
• Make sure to close the door property
and latch it.
• Check drain hose.
• Check the coarse filter. (see section
titled «Internal Care»)
• Check the kitchen sink to make sure
it is draining well. If the problem is
the kitchen sink that is not draining,
you may need a plumber rather than
a serviceman for dishwashers.
• Use only the special dishwasher
detergent to avoid suds. If this
occurred, open the dishwasher and
let suds evaporate. Add 1 gallon of
cold water to the tub. Close and latch
the dishwasher, then Start any wash
cycle to drain out the water.
•
• Repeat if necessary.
• Always wipe up rinse aid spills
immediately.
• Make sure that the detergent has no
colourant.
EN