Idiomas disponibles
Idiomas disponibles
Precautions
1.
Warranty card
The serial number is written on the rear panel of this unit.
Copy the serial number and model number onto your war-
ranty card and keep it in a safe place.
2.
Power
WARNING
BEFORE TURNING ON POWER FOR THE FIRST TIME, READ
THE FOLLOWING SECTION CAREFULLY.
e Some models are designed for use only with the power
supply voltage of the region where they are sold.
e European models:
AC 220V, 50Hz
e Canadian models:
AC 120V, 60Hz
e Worldwide models:
AC 120 and 220V
switchable, 50/60Hz
e Voltage selector (rear panel)
Worldwide models are equipped with a voltage selector to
conform with local power supplies. Be sure to set this
switch to match the power supply in your area before turn-
ing the power switch on. Voltage is changed by sliding
the groove in the switch with a screwdriver to the right or
left. Confirm that the switch has been moved all the way
to the right or left before turning the power switch on.
Models without a voltage selector can only be used in
areas where the power supply voltage is the same as that
of the unit.
220V ~\ 120V
220V © 120V ~
at AC 120V
at AC 220V
WORLDWIDE MODELS ONLY
3.
Deck location
4.
Cassettes to avoid:
System connections
bearing
the "Rt" mark
:
fofe of fe
NF
For playback from deck =>
@™@ For recording on deck
Headphone jack
Dynamic type headphones with a rated impedance in the 8 to 200
ohm range are recommended.
Remote control jack
Note:
Do not attempt to connect the RI remote control jack to any
equipment other than an Onkyo component bearing the RI!
mark. Doing so could cause the unit to malfunction.
Notes:
1) DIN terminal supplied on European models only.
2) Do not connect DIN cords and pin cords at the same time.
