Idiomas disponibles
Idiomas disponibles
4. Place the saw chain (12) into the blade bar
groove. To assemble, hold the blade bar (11) til-
ted upwards at an angle of approx. 45 degrees
in order to be able to guide the saw chain (12)
more easily onto the chain sprocket (17).
5. Place the blade bar (11) and saw chain (12). It
is normal for the saw chain (12) to sag.
6. Turn the screw for the chain quicktensioning
system (8) until the chain tensioner pin (19) is
approximately level with the mounting screw
(16).
7. Place the sprocket cover (9) into position. The
chain tensioner pin (19) on the inside of the
sprocket cover (9) must be guided into the
chain tension pin holder.
8. Screw the Mounting knob (10) into the
threaded screw (16).
9. Pre-tension the saw chain (12) by turning the
screw for the chain quicktensioning system (8)
in the direction.
10. Tighten the mounting knob (10) of the sprocket
cover (
).
Caution! The pruner saw can be prone to
leaks.
Prior to changing the saw chain, the groove of the
guide rail must be cleaned of dirt because dirt de-
posits available can cause the saw chain to break
out of the rail. The deposits can also absorb the
chain oil. So the consequence would be that the
chain oil would not or only a small part of it would
reach the underside of the rail and the lubrication
would be reduced.
Tensioning the saw chain
Regularly tightening the saw chain provides safety
for the user and reduces and/or prevents wear
and chain damages. Before the start of work and
in approx. 10 minute intervals, we recommend the
user to examine the chain tension and correct it, if
necessary. The chain warms up when working with
the saw and thus expands slightly. These "expan-
sions" can be expected especially from newer
chains.
Do not re-tighten or change the chain
when it is hot because it shrinks slightly
once it has cooled down. In case of
non-observance, this can lead to
www.vonroc.com
damages on the guide rail or the engine
because now the chain is too taut on the
blade. Chain tension and chain lubrication
have a significant impact on the service
life of the chain.
The chain is correctly tensioned if it does not sag
at the rail underside and can be rotated comple-
tely around with the gloved hand. When the saw
chain is tensioned with 9 N (approx. 1 kg), the gap
between the saw chain and the guide rail may not
be more than 2 mm.
10 min
9N max. 2 mm
Switch off the device and remove the
battery before carrying out any mainte-
nance work.
1. Loosen the mounting knob (10) of the sprocket
cover (9) (
).
2. To tension
the saw chain, turn the screw
(8) for the chain quicktensioning system in the
direction. To loosen
screw (8) for the quick-tensioning system in the
direction .
3. Tighten the mounting knob (10) of the sprocket
cover (9) again (
The chain tension of a new saw chain
must be readjusted after a maximum of 5
cuts.
Removing/inserting the rechargeable battery
1. To insert the battery (14) into the device, push
the battery along the guide rails into the device.
You will hear them click into place.
2. To remove the battery (14) from the device,
press the release button (14a) on the battery
and pull the battery out.
4. OPERATION
Switch on the chainsaw only when chain
bar, saw chain and sprocket chain wheel
covering are correctly assembled.
Make sure you have a secure stance.
Before starting, ensure that the electric
the tension, turn the
).
11
EN
