Idiomas disponibles
Idiomas disponibles
1.
Connect the battery pack
charger
.
21
2.
Insert the mains plug into the socket. The
charging status LED
same time the green charging status LED
will extinguish. Once the battery pack
is completely charged, the green charging
status LED
is lit continuously, indicating
22
that the charging process is complete. At the
same time the red charging status LED
extinguish.
3.
Disconnect the charger
and remove the battery pack
charger.
4.
Attach the battery pack
product.
Charging status LEDs
Green LED flashing Charger ready
Red LED
Battery pack charging
continuously lit
Green LED
Battery pack fully charged
continuously lit
Red and green
Battery pack defect
LEDs flashing
Red and green LEDs
Battery pack too cold or
continuously lit
warm
Checking the battery level
Q
Press the battery charging level button
o
to check the charging level of the battery
pack
. The status / remaining charge
17
will be shown on the battery charging level
20
indication light
.
4 Green LEDs
Battery pack fully charged
continuously lit
3 Green LEDs
Battery pack 75% charged
continuously lit
2 Green LEDs
Battery pack 50% charged
continuously lit
1 Green LED
Battery pack 25% charged
continuously lit
1 Green LED
Low battery charging level
flashing
Charge the battery pack
o
when it is at medium or low battery charging
level.
to the battery
17
lights up red, at the
23
22
17
will
23
from the mains
21
from the
17
back to the
17
18
17
before operation
Safety functions
Q
A
Rear handle with rear guard
1
Apart from protecting your hand if the
saw chain
jumps or snaps, the rear
5
guard
stops branches and twigs from
9
interfering with your grip on the rear
handle
.
1
Front guard / chain brake
3
The chain brake
which stops the saw chain
in case of a spring-back; chain brake can
also be activated manually; protects the
left hand of the operator if it slides from the
front handle
11
Saw chain with low kickback
5
Helps to catch kickbacks with specially
developed control systems.
Spiked bumper
10
Spiked bumper
the power tool. Installation is not required.
Do not disassemble or make adjustment
on the spiked bumper
be running at full speed before the spiked
bumper
contacts with the wood. Use the
10
spiked bumper
on the wood. Use the spiked bumper
a leverage point while cutting.
On / off switch with safety
13
chain brake
On releasing the on / off switch
product immediately switches off.
Lock-off button
14
The lock-off button
switching on the product.
is a control system,
3
immediately
5
.
was pre-installed on
10
. The chain must
10
to support the chain saw
10
10
, the
13
must be pressed for
14
GB / IE
9
as
35
