Idiomas disponibles
Idiomas disponibles
7.
Cut in a number of stages if the area being
cut is particularly long to achieve a better
result; smaller cuttings will allow for easy
composting.
8.
Lubricate the internal surfaces of the blade
if the cutting device
operation.
After use
Q
1.
Switch the product off, remove the battery
pack
and let it cool down.
14
2.
Check, clean and store the product (see
"Cleaning and care").
Cleaning and care
Q
WARNING!
Always switch the product off, remove
the battery pack and let the product
cool down before performing inspection,
maintenance and cleaning work!
Cleaning
Q
The product must always be kept clean, dry
o
and free from oil or grease. Remove debris
from it after each use and before storage.
Regular and proper cleaning will help ensure
o
safe use and prolong the life of the product.
Inspect the product before each use for worn
o
and damaged parts. Do not operate it if you
find broken and worn parts.
Never allow fluids to get into the product.
o
Clean the product with a dry cloth. Use a
o
brush for areas that are hard to reach.
In particular clean the air vents after every
o
use with a cloth and brush.
Remove stubborn dirt with high pressure air
o
(max. 3 bar).
NOTE
Do not use chemical, alkaline, abrasive or
u
other aggressive detergents or disinfectants
to clean this product as they might be harmful
to its surfaces.
overheats during
2
Maintenance
Q
Before and after each use, check the product
and accessories (or attachments) for wear and
damage. If required, exchange them for new ones
as described in this instruction manual. Observe
the technical requirements (see "Technical data").
Cutting device (blade)
Q
WARNING!
Wear safety gloves when working on
the cutting device and close to it! Use
appropriate tools to remove debris, e. g.
a brush or wooden stick! Never use your
bare hands!
Always use original spare parts for
replacement. Do not attach any other
type of cutting device!
The replacement of the cutting device
should be done by a qualified specialist!
Rework or sharpening blades is not
recommended unless it is done by a
repair service or a similarly qualified
specialist!
1.
Switch the product off and remove the battery
pack
.
14
2.
Keep the cutting device
debris. Remove trimmings.
3.
Apply a small amount of suitable lubricant
on the cutting device to retain a good cutting
performance (see Fig. I).
4.
Keep the cutting device
worn or damaged cutting device
with a new one of the same type by a
qualified specialist.
Repair
Q
This product does not contain any parts that can
be repaired by the user. Contact an authorised
service centre or a similarly qualified person to
have it checked and repaired.
clean and free of
2
sharp. Have a
2
2
replaced
GB / IE
31
