Idiomas disponibles
Idiomas disponibles
1
1.1
UNPACKING
For future use, remove all protective elements.
Check and respect the appliance's characteristics
that appear on the nameplate.
Note in the boxes below the service and standard
references shown on this plate.
Service :
1.2
FITTING INTO THE WORK TOP
Check that the air intake and outlet are free of
obstruction (1.2.1).
For standard fitting, refer to diagrams A or C.
For flush-fitting, refer to diagrams B or D.
Comply with the information concerning the
fitting dimensions (in millimetres) of the work top
destined to receive the hob (1.2.2). Glue the
sealing joint to the entire surround of the hob
(depending on model) (1.2.3), before fitting.
Check that air circulates correctly between the
front and the back of your hob.
If you are installing the hob above a drawer
(1.2.4) or above a built-in oven (1.2.5), comply
with the dimensions provided on the illustrations
to ensure a sufficient air outlet at the front.
If your hob is located above your oven, the
hob's thermal safety devices can impede the
simultaneous use of the hob and the oven's
pyrolysis programme, display code "F7" in the
control zones. In such circumstances we
recommend that you increase the hob's
ventilation by creating an opening in the side of
the cabinet (8 x 5 cm).
1. 3
ELECTRIC CONNECTIONS
These hobs must be connected to the power grid
via an all-pole cut-off device that complies with
installation regulations in effect. A disconnection
device must be incorporated into the fixed wiring.
Identify the type of cable of your hob according
to the number of wires and colours:
- 3-wire cable (1.3.1):
a) green-yellow, b) blue, c) brown.
- 5-wire cable (1.3.2 and 1.3.3):
a) green-yellow, b) blue, c) brown, d) black,
e) grey.
When switching your hob on or after a lengthy
Type :
power cut, a code is shown on the control pad
(this display is reserved for your after-sales
service, where applicable. The user of the hob
does not need to take notice of it).
This
information
30 seconds.
2
Identify your type of hob
i
j
by comparing the number and
arrangement of burners, the type of keypad and
the total power of your appliance using the
illustrations with the nameplate.
3
3.1
CHOICE OF COOKWARE
Cookware with the
with induction.
We suggest that you choose cookware
with a thick and flat bottom. The heat
will be distributed better and cooking will be
more uniform.
Advice on how to save energy
Cooking with the correctly sized lid saves
energy. If you use a glass lid, you can
control your cooking perfectly.
3.2
BURNER SELECTION
Select the burner which is the right size for the
bottom of your cookware (see table). If the base
or the cookware is too small, the power indicator
will start to flash and the burner will not work,
even if the cookware's material is recommended
for induction.
disappears
after
around
symbol are compatible
