Philips NORELCO OneBlade QP6530 Manual Del Usuario página 3

Ocultar thumbs Ver también para NORELCO OneBlade QP6530:
Idiomas disponibles

Idiomas disponibles

- Always attach power cord to product first,
then to power outlet. To disconnect, set all
controls to 'off' position. Then remove
power cord from power outlet.
- Unplug power cord before plugging in or
unplugging the product.
- Only use the power cord and other
accessories supplied with the product.
- Do not attempt to open the product to
remove or replace the built-in rechargeable
battery.
- The batteries used in this product may
present a fire or chemical burn hazard if
mistreated. Do not disassemble, heat above
100 °C (212 °F) or incinerate.
IMPORTANT: The power plug contains a
transformer. Do not cut off the power plug to
replace it with another plug as this will cause a
hazardous condition.
SAVE THESE
INSTRUCTIONS
Introduction
Congratulations on your purchase and
welcome to Philips Norelco!
To fully benefit from the support that Philips
Norelco offers, register your product at
www.philips.com/register.
General description (Fig. 1)
1 Blade
2 Blade release slide switch
3 On/off button
4 Battery charge indicator
5 Socket for small plug
6 Body comb
7 Skin guard
8 Hair length setting wheel
9 Precision trimming comb
10 Power cord with plug
11 Small plug
12 Pouch
This symbol indicates that the product can be
used in the bath or shower.
The display
Battery low
- When the battery is almost empty, the
bottom light of the battery charge indicator
starts flashing orange (Fig. 2).
Charging
- When the product is charging, the bottom
charging light starts flashing white, then
the next one and so on (Fig. 3).
Battery full
- When the product is fully charged, all
battery charge indicators light up white.
Remaining battery charge
- The remaining battery charge is indicated
by the lights of the battery charge indicator
that light up continuously.
Charging
Charging takes approx. 1 hour.
- Charge the product before first use and
when the display indicates that the battery
is almost empty.
- Charging or using the product at
temperatures below 40 °F (4.5 °C) or higher
than 95 °F (35 °C) adversely affects the
lifespan of the battery.
- If the product is subjected to a major
change in temperature, pressure or
humidity, let the product acclimatize for 30
minutes before using.
Quick charge: During quick charge, all three
lights of the battery charge indicator light up.
After approx. 5 minutes of charging, the
product contains enough energy for 5 minutes
of use. When quick charge is finished, the
bottom light of the battery charge indicator
starts to flash.
Charging with the power cord
1 Make sure the product is switched off.
2 Insert the small plug into the product and
put the power plug in any 120V AC outlet
(Fig. 4).
3 After charging, remove the power plug
from the wall outlet and pull the small plug
out of the product.
Note: Approx. 30 minutes after the battery
is fully charged or when you disconnect the
loading