Idiomas disponibles
Idiomas disponibles
3.
Make sure that the J-shaped end on the Roller Pin is
secured in the mounting hole of the Left Roller Bracket (#6)
and then secure the end on the Roller Pin with a 1/2 Lock Nut
(#4). See Figure 1-11.
4.
The roller can be adjusted to two different heights. To
change the height of the striper kit, remove the Locknut
and slide the pin out far enough to move it into the desired
height setting on the right side of the bracket. Secure the
hooked end of the pin and install the Locknut to lock into
position. See Figure 1-12.
NOTE: Deck wheels may need adjusted for maximum
striping performance. See your Tractors Operator Manual
for instructions on adjusting the deck wheels.
6
S
2 — i
ection
nStallation
Figure 1-11
Figure 1-12
46" Deck Striper Kit - Model 19A70061OEM
Model 19A70061OEM striper kit is designed for use with
select Residential Zero Turn (RZT) mowers. Refer to your RZT's
Operator's Manual to assure compatibility.
Carton Contents - Model 19A70061OEM
Before beginning installation, remove all parts from the carton
to make sure everything is present. Carton contents are listed
below. Part numbers are shown in parentheses. See Figure 1-13.
1.
Four Hex-head Capscrews, 5/16-18 (710-3038)
2.
One Roller Pin (711-08681)
3.
Four Lock Nuts, 5/16-18 (712-04063)
4.
One Lock Nut, 1/2-13 (712-3083)
5.
Four rollers (731-17871)
6.
One Right Roller Bracket (789-02457)
7.
One Left Roller Bracket (789-02458)
1
5
Figure 1-13
46" Deck Striper Kit Installation - Model
19A70061OEM
To install the Striper Kit on Tractors equipped with a 46" stamped
or fabricated deck proceed as follows:
2
3
6
7
