Silverline 128999 Manual Del Usuario página 10

EN
Adjusting the Scale
0-90° Scale:
1. Place the tool Fence face down on a flat surface
2. Tighten the Angle Locking Knob (8)
3. Loosen the two Scale fixing screws
4. Align the Scale with the lower arrow to 0°
5. Retighten the fixing screws
6. Carry out test cuts on a scrap piece of material to ensure the tool is calibrated correctly
90-135° Scale:
1. Place the tool upside down on a flat surface
2. Set the Adjustable Fence to 90° using an engineers' square
3. Tighten the Angle Locking Knob
4. Loosen the two upper scale fixing screws
5. Align the Scale with the upper arrow to 90°
6. Retighten the fixing screws
7. Carry out test cuts on a scrap piece of material to ensure the tool is calibrated correctly
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the machine's service life. Clean the body of your machine with a soft brush, or dry cloth.
If available, use clean, dry, compressed air to blow through the ventilation holes
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking
• If you suspect that the brushes may be worn, have them replaced at an authorised Silverline
service centre
Note: One pair of spare carbon brushes is supplied with this tool.
Storage
Store this tool carefully in a secure, dry place out of the reach of children
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web: www.silverlinetools.com
UK Address:
Toolstream Ltd.
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
EU Address:
Toolstream B.V.
Hogeweg 39
5301 LJ Zaltbommel
The Netherlands
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
10