Fuel Recommendations - Honda FRC800 Manual Del Propietário

SERVICING YOUR TILLER
Refuel in a well-ventilated area before starting the engine. If the engine
has been running, allow it to cool. Refuel carefully to avoid spilling fuel.
Do not fill the fuel tank above the fuel level mark. After refueling, tighten
the fuel tank cap securely.
Never refuel the engine inside a building where gasoline fumes may
reach flames or sparks. Keep gasoline away from appliance pilot lights,
barbecues, electric appliances, power tools, etc.
Spilled fuel is not only a fire hazard, it causes environmental damage.
Wipe up spills immediately. If fuel is spilled on clothing, change clothing
immediately.
If fuel is spilled, do not attempt to start the engine but move the machine
away from the area of spillage and avoid creating any source of ignition
until fuel vapors have dissipated.
Fuel can damage paint and plastic. Be careful not to spill fuel when filling
your fuel tank. Damage caused by spilled fuel is not covered under
warranty.

FUEL RECOMMENDATIONS

A1 and C1 types
This engine is certified to operate on unleaded gasoline with a pump
octane rating of 86 or higher.
MX1 and U1 types
This engine is certified to operate on unleaded gasoline with a research
octane number of 91 or higher.
You may use regular unleaded gasoline containing no more than 10%
ethanol (E10) or 5% methanol by volume. In addition, methanol must
contain cosolvents and corrosion inhibitors.
Use of fuels with content of ethanol or methanol greater than shown
above may cause starting and/or performance problems. It may also
damage metal, rubber, and plastic parts of the fuel system.
Engine damage or performance problems that result from using a fuel
with percentages of ethanol or methanol greater than shown above are
not covered under warranty.
Never use gasoline that is stale, contaminated, or mixed with oil. Avoid
getting dirt or water in the fuel tank.
If your equipment will be used on an infrequent or intermittent basis,
please refer to the fuel section of the STORAGE chapter (see page 55) for
additional information regarding fuel deterioration.
33