Idiomas disponibles
Idiomas disponibles
EN - Safety instructions
• Product must be installed by a qualified
person in accordance with the regulations
in force. The manufacturer shall not be
held responsible for damages arising from
procedures carried out by unauthorized
persons which may also void the warranty.
• Preparation of location and electrical
installation for the product is under
customer's responsibility.
• The product must be installed in
accordance with all local electrical
regulations.
• Before installing the product, remove all the
materials and documents in it and visually
check if the product has any defects on it.
If so, do not have it installed.
• The product is heavy, carry the product
with at least two people.
• The door and/or handle must not be used
for lifting or moving the appliance. Use the
lifting spaces on both sides of the product
(figure 1). Always wear protective gloves
during transport and installation.
• Disconnect electrical connections in the
area to be installed before installation.
• The surfaces of the furniture that the oven
is to be installed in must be heat-resistant
(100 °C minimum).
• Make sure the furniture is fixed before
installing the product.
• Do not install heat insulation strips inside
the interior of the furniture that the oven is
to be installed in.
• The appliance must not be installed
behind a decorative door in order to avoid
overheating.
• The dimensions given in the installation
diagrams are in mm.
Installing the product
If the product will be placed under
the counter: (Figure 2)
• In order to provide the necessary ventilation
in the back of the kitchen furniture,
openings should be created in the
dimensions shown in figure 2.
• The electrical connection must be in the
area A in figure 2 or outside the installation
site.
• If the product is to be placed under a hob,
follow the dimensions given in the hob
installation manual.
4
If the product will be placed in the tall
cabinet: (Figure 3)
• In the back compartment of the kitchen
furniture, openings should be created in
the dimensions shown in figure 3 in order
to provide the necessary ventilation. This
opening should be along the height of the
cabinet.
• If there is a back panel of the tall cabinet
where the product will be placed, it must
be removed.
• The electrical connection must be in the A
area in figure 3 or outside the installation
area.
If the product will be placed to
corner: (Figure 4a-4b)
• Attention should be paid to the dimensions
given in order to make the corner
installation in the figure 4a and 4b.
Connecting the appliance to the
electricity supply
• Only connect the product to a grounded
outlet/line with the voltage and
protection as specified in the "Technical
specifications". Have the grounding
installation made by a qualified electrician
while using the product with or without
a transformer. Our company shall not be
liable for any problems arising due to the
product not being earthed in accordance
with the local regulations.
• Before starting any work on the electrical
installation, disconnect the product from
the mains supply. There is the risk of
electric shock!
• The product must be connected to the
mains supply only by an authorised and
qualified person. The product's warranty
period starts only after correct installation.
Manufacturer shall not be held responsible
for damages arising from procedures
carried out by unauthorised persons.
• The appliance must be installed so that
it can be completely disconnected from
the mains supply. The separation must
be provided by a switch built into the
fixed electrical installation, according to
construction regulations.
• Rear surface of the oven gets hot
when it is in use. Make sure that the
electrical connection does not come into
contact with the rear surface otherwise,
connections can get damaged.
